CNC UHU SERVO CONTROLLER WITH OPTICAL ENCODER FEEDBACK IN PRETORIA

UHU SERVO CONTROLLER BUILDING YOUR OWN CNC MACHINE - OR HAVE A MANUAL CNC THAT YOU NEED TO BE RETROFIT? THIS CONTROLLER PACKS A MIGHTY PUNCH!!! IT BOASTS WITH A 4.5 KW POWER CAPABILITY - THIS IS SERIOUS POWER - AND CAN DRIVE HUGE CNC MACHINES FITTED WITH FANUC, GIDDY'S, HEIDENHEIN, SIEMENS, ECT. - MOTORS. SHOULD YOU BE BUILDING YOUR OWN MACHINE - YOU CAN USE ANY DC PERMANENT MAGNET MOTOR - AND FIT AN ENCODER TO IT - THIS WILL GIVE YOU A PROPER CLOSED LOOP SYSTEM - ENSURING YOUR CNC KNOWS WHERE IT IS AT ALL TIMES. YOU CAN USE WIPER MOTORS AND FIT THE ENCODERS TO YOUR DRIVE PULLEYS. THE CONTROLLER INT E GRATES FULLY INTO MACH 3 - OR LINUX CNC - IT USES STEP AND DIRECTION INPUTS. THE CONTROLLER WILL COMFORTABLY HANDLE 80 VOLTS AND 30 AMPS - IT WAS DESIGNED FOR THIS. TIRED OF TOYING AROUND WITH STEPPER MOTORS - AND SKIPPING STEPS - NOW YOU CAN HAVE A PROPER SOLUTION - AND JOIN THE REAL CNC COMMUNITY.   CONTROLLER SPECS:   Platform: Atmel Attiny Operating frequency: 24 MHz Operating principle: enhanced PID Loop parameters: 3 setups storable in EEPROM and secured by forward error correction Speed: up to steps/s (4-fold encoder steps) Communication: interface: RS Bit, 1 Stop, No Parity - For Controller Tuning logic: command line, plain text Inputs PC: step/dir - Either from Parallel Breakout Board - or Arduino. encoder: A/B 90°, 4-fold  emergency stop: Active Low Outputs: Ready (LED) PWM (10 Bit, symmetric) power enable error (LED) Enhanced functionality: - Higher derivative feedback for stabilisation with minimal impact on   positioning error - adjustable tracking-error shutdown - detection of false encoder inputs - loop in of error conditions - step multiplier for the use of high resolution encoders - continous output of tracking error values for visualisation on external PC   PCB   Size: 1/1 euro format (160x100mm) Technology: double sided, SMD, EMC optimized Power stage: - MOS-FET technology - adjustable maximum current  IRFP260N max.30A/80V  Interfaces: encoder: TTL step/dir: TTL through opto coupler RS232: V.24 with built in level shifter and 1:1 connector SubD9 error in/out: 5 V wired-or, active low Power supply: 12 V regulated (logic)