Tork craft flush wood

Top sales list tork craft flush wood

Tork craft 5 piece wood turning chisel set (w0601)

South Africa

Tork Craft 5 Piece Wood Turning Chisel Set (W0601) Description: - 5 Piece Wood Chisel Set

See product

Tork craft screw pilot no.8 carded (tz ac26-8)

South Africa

Tork Craft Screw Pilot No.8 Carded (TZ AC26-8) Screw Pilot 90° Countersink with drill bit A convenient power tool accessory. Allows you to drill a hole and simultaneously countersink the hole for screws. A common use is to allow the head of a countersunk bolt or screw, when placed in the hole, to sit flush with or below the surface of the surrounding material. This accessory will just allow you to drill and countersink in a singel step. Accurate at all times and a very neat job. A countersink is a conical hole cut into a manufactured object.

See product

Tork craft plug dowel cutter 20mm (w60020)

South Africa

Tork Craft Plug Dowel Cutter 20mm (W60020) Plug cutters A plug cutter is used to make a timber plug to hide a drilled hole. INSIDE DIAMETER: Ø20mm MATERIAL: Hardened steel with a shear angle design for smooth and easy cutting Application: There is a variety of different plug cutters in the range, depending on the diameter hole that needs to be plugged. The plug cutter is measured on the inside diameter. Always make sure that the hole is drilled to correspond to the correct plug cutter. The benefits of using plug cutters: The same wood can be used to match with the current timber.The grains can be alligned to hide the plug even better Excess offcut timber can be used to drill the plugs. Plug cutters can be used to hide imperfections in wood TIP: For best results, use a drill press to cut all the plugs to the required depth. A band saw can then be used to remove the plugs from the offcut.

See product

Tork craft countersink carb.steel 1/4" (6.35mm)

South Africa

Carbon Steel Countersink Countersink for Wood A countersink is a conical hole cut into a manufactured object. The same term is used for the cutter used to cut such a hole. Common uses: A common use is to allow the head of a countersunk bolt or screw, when placed in the hole, to sit flush with or below the surface of the surrounding material. A countersink may also be used to remove the burr left from a drilling or tapping operation thereby improving the finish of the product and removing any hazardous sharp edges. Regardless of the name given to the cutter, the surface being generated may be a conical chamfer (plunging applications) or a beveled corner for the intersection of two planes (traversing applications). These Tork Craft carbon countersinks are referred to as fluted countersinks and mainly suitable for wood Made in China to Tork Craft specifications

R 30

See product