Microcare 100amp solar

MicroCare MPPT 100Amp Automatic selection of Battery voltage (24 - 48V). Li-Ion compatibility and 12V units available on request. Input panel voltage (20-150Voc). Circuit Breaker protection - Full input and output protection. Electronic current limiting. 4 Line LCD Display: 1. Battery Voltage, 2. Charge Mode. (Equalize, Boost and Float) showing Charge Current,3. Panel Voltage and 4. Output Power from the Panels. Data Logger: 24hr Average and 63-day logger. Programmable features. Accessories: Programmable Relay. Peak efficiency greater than 96%. Advanced constant Power Point Tracking algorithm. Available with Comms port for Wi-Fi access. Technical Data Output Current Rating: 100A. Nominal Battery Voltage: Multi-Voltage (Automatic/Manual selection of voltage - 24/36/48V). PV Input Voltage: Open Circuit Absolute Maximum 150VDC. Charge Algorithm: 5-stage 3-level (Equalize/Boost/Float). Equalize Voltage: Charges to 15V per battery (Timed or Full). Boost Voltage: Default charges to 14.5V (Set capable). Float Voltage: Default 13.8V per battery (Set capable). Power Conversion: DC/DC Switch Mode. Voltage Step Down: Can charge a lower voltage battery from a higher voltage PV array. Power Consumption: Less than 1W. Environmental Rating: 0 – 40ºC. Input: 100A DP Input Circuit Breaker. Output Connection: 100A DP Output Circuit Breaker. Cabinet Dimension: 350mm (L) x 220mm (W) x 130mm (H). Weight: 5kgs.

Buy 1,5kW 380V MICROCARE 3-phase Solar Pump Controller (Compatible for 220V and 380V VSD motors) for R12,250.00

Microcare Inverters are Pure Sine Wave Bi-Directional Inverters designed to obtain optimum inverted AC power from an installed DC Solar System. Using the latest in-house designed software, the Microcare Inverter can improve the automatic change-over from the grid to the inverter allowing for an uninterrupted power supply to a range of applications from a sensitive server room to industrial machines. The locally designed Microcare Inverter can anticipate load failure by pre-charging the circuits for rapid transfer of power and change-over. When the grid power returns with a fluctuating voltage, the Microcare Inverter delays the transfer to a set connection time to avoid any load damage. Microcare Inverters use galvanic isolation resulting in the product being highly robust and reliable with low standby current and high efficiency ratings.

Microcare 5kVA Pure Sine Inverter *48V input *220V output *Input Amps 125 *Output Amps 22 *Can be used in Grid Tie. Including Microcare 60 Amp MPPT charge controller. No Swaps! Port Elizabeth Only

  Microcare Data Acquisition Cable is used to connect a MICROCARE   LCD  MPPT directly to PC to monitor power production: software  supplied. The link for software will be supplied with unit. Application:  The purpose of this cable & software is to provide real-time visual feedback of the performance of the machine. By viewing the graphs one will be able to track such aspects as the Charge voltage, current and power  in real time. You will be able to plot any 2 of these side by side as required for analysis. You will also be able to program the MPPT by sending it calibration and settings information.  Computer system requirements: A computer/Laptop running Microsoft Windows 7 and Microcare Data Acquisition Software as supplied by link on receipt of Data Cable. CPU: A Pentium 1.0 GHz processor is the minimum recommendation. For best performance, a Pentium 1.7 GHz or faster is suggested. Equivalent AMD processors are also supported. Memory: Minimum 256MB, Recommended 1GB 1 USB port.                Shipping from PE, please see shipping tab. Payment within 48 hours preferred, maximum 7 days.   Order Lead time +/- 7 working days from receipt of payment.  Combined purchases from Microcare can be sent as one consignment and will make shipping more economical. For more Solar items, including all Microcare solar components, see my listings electronics - other electronics.   CLICK  BELOW    

                                                          Why you should consider buying a MICROCARE product: Proudly South African with 20 years of manufacturing with many units having been sold locally and internationally. Service and repair of the products at a minimum cost due to local manufacture.  30amp SOLAR LED MPPT Regulator with Auto plus Load Shed ( 12-24v)           Overview:   The MICROCARE MPPT REGULATOR is designed to interface between the SOLAR PANEL, the BATTERIES and the LOAD. This  TRACKER will always find the optimum power point of the solar panel system to ensure that maximum power is extracted from the solar panel and put into the batteries. Using this system up to 30% more power can be extracted from the solar panel  than using shunt or series pass regulators. This  MICROCARE MPPT REGULATOR is also able to charge batteries of a lower voltage than the solar panel. By means of LEDS it will show the status of the system. It also incorporates various charge modes which will automatically increase the charge level to the batteries when first starting up or if the battery voltage falls below the minimum volts. This MICROCARE MPPT REGULATOR will read the nominal battery voltage. This unit is designed to run on a 12/24 volt battery set. It will then read the solar panel voltage and automatically find the optimum power point. The charging, battery values and boost modes are then automatically adjusted. Via links the load voltage disconnect can be selected, whether the battery is lead acid or sealed, and whether the unit operates as a normal load shedder or as a day/night switch.   Features:   Automatically measures the battery voltage and then sets up the charge parameters (12v-24v). Operates the Solar Panels at the maximum efficiency. Charges batteries by setting up the best power point of the solar panels. Can improve power extracted from the solar panels by 30% over normal shunt/series pass regulators. LED Display gives status notification. Charges batteries by setting up the best power point of the  solar panels. Temperature controlled Cooling Fan. Selectable low voltage disconnect (12v system - 10v, 10,7v, 11,5v and 24v system 20.0v, 21,4v, 23.0v).  24 hour load or Day/Night mode (Programmable: Dusk to Dawn - 1/2 hour, 1 hour or 1,5 hour delays). Protection system: Lighting protection, reverse polarity panel/battery, internal fuse. Maximum Current 30 Amps. 30 amp Load controller.           Order Lead Time: From receipt of your payment approx 5 - 7 working days before order will be ready for shipping.      For other related SOLAR items you can use the link below, listed under category Electronics, sub-category Other electronics.   CLICK BELOW         

     60amp SOLAR LCD MPPT Regulator Auto (12-48v)                                      Why you should consider buying a MICROCARE product: Proudly South African with 20 years of manufacturing with many units having been sold locally and internationally. Service and repair of the products at a minimum cost due to local manufacture.                         MPPT OPERATION DESCRIPTION:         Above and below schematics show how an MPPT functions during the course of a day.   In the morning, as soon as the MPPT detects that the Panel Voltage is at a usable level (MPPT charge entry voltage): it starts to charge the batteries at maximum efficiency in a BOOST mode which has a nominal voltage of 14.5V per 12V battery bank. If however the batteries are detected to not be uniformly discharged, the MPPT will go into EQUALISE mode to restore the battery bank balance before switching to BOOST mode as its primary charge mode.. The MPPT maintains this mode until the batteries reach the boost voltage and the charge current decreases to a level below a nominal changeable level of 6 Amps. The MPPT then steps down the charge voltage to a nominal voltage of 13.8V per 12V battery bank in FLOAT mode. The MPPT will attempt to maintain FLOAT mode for as long as the panel voltage is present. If no panel voltages present, the MPPT goes into a sleep state until it detects a rise in panel voltage indicating a new day for charging.               Shipping: See shipping tab.   Payment: Within 48 hours preferred. Maximum 7 days.   This is a promotional price, all orders placed towards the end of the promotion which ends on the 31st May 2018 must be paid before close of business (17H00) on the 31 May 2018.          For SOLAR PANELS, please see my listings under Electronics, other electronics.       CLICK BELOW      

     60amp SOLAR LCD MPPT Regulator Auto (12-48v)                                      Why you should consider buying a MICROCARE product: Proudly South African with 20 years of manufacturing with many units having been sold locally and internationally. Service and repair of the products at a minimum cost due to local manufacture.                         MPPT OPERATION DESCRIPTION:         Above and below schematics show how an MPPT functions during the course of a day.   In the morning, as soon as the MPPT detects that the Panel Voltage is at a usable level (MPPT charge entry voltage): it starts to charge the batteries at maximum efficiency in a BOOST mode which has a nominal voltage of 14.5V per 12V battery bank. If however the batteries are detected to not be uniformly discharged, the MPPT will go into EQUALISE mode to restore the battery bank balance before switching to BOOST mode as its primary charge mode.. The MPPT maintains this mode until the batteries reach the boost voltage and the charge current decreases to a level below a nominal changeable level of 6 Amps. The MPPT then steps down the charge voltage to a nominal voltage of 13.8V per 12V battery bank in FLOAT mode. The MPPT will attempt to maintain FLOAT mode for as long as the panel voltage is present. If no panel voltages present, the MPPT goes into a sleep state until it detects a rise in panel voltage indicating a new day for charging.               Shipping: See shipping tab.   Payment: Within 48 hours preferred. Maximum 7 days.   This is a promotional price, all orders placed towards the end of the promotion which ends on the 30th July 2018 must be paid before close of business (17H00) on the 30th July 2018.          For SOLAR PANELS, please see my listings under Electronics, other electronics.       CLICK BELOW      

Buy 10A 12-24V Microcare Solar LED MPPT Charge controller regulator with Auto plus Load Shed for R2,250.00

                                                                                                                                                                                                                                                                                                                                                  Warranty - Carry in.      The 600w Solar Home System has a 3 year warranty     The panels are 305w Polycrystalline with a 10 year warranty       The batteries have a 1 year warranty       Order Lead Time: From receipt of your payment approx 5 - 7 working days before order will be ready for shipping.                                                                                                                       CLICK BELOW  TO  SEE  MY  LISTINGS:           

    How the unit looks with the cover closed.                                       This shows how the batteries fit into the casing. Note: No batteries included. Warranty - 3 year Carry in.   The unit is on casters so it is easy to move the system around & the built in battery compartment helps keep wiring to a minimum.    Before ordering you need to ask a question to confirm price and to get a shipping quote. Please supply Area code, town and suburb. Payment: Within 48 hours preferred, maximum 7 days.   CLICK BELOW     

Please note image is that of the 2 string - the price and the details supplied on this listing is for the 1 string 600V Microcare High Voltage DC Surge Protection Unit with DC Disconnect for the Microcare Solar Pump Controller.   The Microcare High Voltage Surge Protection Unit for Solar Pump controllers will provide safety and surge protection for your system. The unit offers isolation between the DC voltages that are generated by the PV modules and the solar installation allowing for safety while working or maintaining the system. With fusing and short circuit protection the PV modules and components can operate optimally with lightning protection included. The unit allows for lightning protection of the pump controller while offering individual string protection. Features: For surge protection on PV Strings Surge / Lightning Protection Isolation of PV DC voltages Fuse Protection Easy MC4 cable connectors Easily connect PV arrays to solar equipment For series string application only. DO NOT parallel the input strings                                                                                                                                        Order Lead time: From receipt of your payment approx 5 working days for order to be ready for shipping.                                             To view my other listings,    CLICK  BELOW         Solar related items are all under category Electronics, sub category other electronics