PVC WALL CLADDING INSTALLATION GUIDE IN SOUTH AFRICA

Prepare the walls so there is no dust, moisture/damp, protrusions or indentations.
You may have decided not to use any base trims and simply silicone the bottom of the sheets after
installation. Otherwise:
Using pins, screws, hammer fixings or adhesive, Install either your:
“J” edging/starter trim to the bottom of the wall so that it sits on the floor. Check how level the floor is as
you may have to cut your sheets to suit,2x2 composite boards for sale in Brazil although you do get a bit of room to manoeuvre within the “J”.
OR
Single or 2part “H” Section 100mm off the floor. This is only necessary if you are having flooring coved up
to meet your sheets. Start at one point and mark 100mm off the floor, then using a level follow this height
and mark a line around the rest of the walls.
Measure out the desired area to be cladded and mark out on your wall where each sheet will start and
finish. If you are cladding up to or around corners, check how level the walls are as you may have to scribe
and cut your sheets to suit.[url=http://www.woodplasticcompositepanel.com/project-case/wood-plastic-composite-siding-and-roofing]Wood plastic composite Siding and Roofing market in North American[/url]
Measure twice cut once!! With your sheet laid out on a work bench, mark out your dimensions. Then,
using either use a decent pair of aviator snips or a jigsaw with a fine PVC cutting blade, carefully and slowly
cut along your marked lines.best composite decking boards price in Norway Always peel back the film a little bit all around the sheet to prevent it getting
trapped in the profiles.

The resources come from:http://compositedeckingfloor.com